Disclaimer: The information in this site is provided to you as a free service. We strive at ProgramAutoRemote.com to have the most current and accurate information. ProgramAutoRemote.com and its creators assume no responsibility for the accuracy or inaccuracy of the information provided.

spacer

2008 Mazda Mazda 6 Key Fob Programming Instructions

2008 Mazda 6

  1. Close all doors, open drivers door, key out of ignition.
  2. Lock and Unlock the drivers door using the power lock switch on door panel.
  3. Insert key into the ignition.
  4. Turn key to the ON and OFF position 3 times in 10 seconds. Leave key in ignition.
  5. Close and open drivers door 3 times ending with door in the open position.
  6. Door locks should respond by locking and unlocking.
  7. Press any button on remote 2 times. Doors should then lock and unlock.
  8. If programming a second remote press any button on it 2 times and door locks should lock and unlock.
  9. Remove key from ignition and locks should lock and unlock again.
  10. Test Remotes