Disclaimer: The information in this site is provided to you as a free service. We strive at ProgramAutoRemote.com to have the most current and accurate information. ProgramAutoRemote.com and its creators assume no responsibility for the accuracy or inaccuracy of the information provided.

spacer

1996 Chevrolet S10 Pickup Key Fob Programming Instructions

1996 S10 Pickup

DATA LINK CONNECTOR

Chevrolet S10 Pickup data link connector
  1. Locate the Data Link Connector (DLC) underneath the driver's side dashboard. Use the figure as a map for your DL ( They are not lettered on your vehicle.) The view is looking straight into the cavities of the DLC.
  2. Connect cavity G with cavity A using a fused jumper wire. Your vehicle will respond by locking and unlocking the door locks within 2 seconds.
  3. Press any button 3 times in successtion on first remote to be programmed. Locks will lock and unlock verifying remote was programmed.
  4. Press any button 3 times in succession on second remote to be programmed if applicable. Locks will lock and unlock to verify remote was programmed.
  5. Remove jumper wire and test remote(s)